Type: AL - Forked clamping arm, with two flanged washers
Product description
Toggle clamps GN 810.3 are latched in both end positions. In the clamped position, this prevents unintentional opening or opening caused by vibrations; and in the open position, it prevents self-closing of the toggle clamp, such as due to an extended clamping arm. The latching can be disabled with a single hand to allow for opening / closing.
They work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical position.
Toggle clamps in the U-bar version with two flanged washers (type AL) can accommodate an application specific clamping screw. A clamping screw with neoprene rubber tip is also included for type CL.
Type EL version can be utilized by welding the clasp which can then accommodate an application specific hold-down fastener component, to hold the work piece in place.
Specification
Tensioning mechanism
Stainless steelNI
- Sheet metal parts AISI 304
- Bearing pins / Bearing rivets AISI 304
- Moving parts lubricated with special grease
Handle
Plastic
Red, oil resistant
Flanged washers GN 898 for type AL / CL
Stainless steel AISI 304
Clasp for type EL
Stainless steel AISI 304
Clamping screws GN 708.1 for type CL
- Stainless steel AISI 304
- Rubber tip
- 85 Shore A
- Type A (flat pressure area)
RoHS
Accessory
Holders for Clamping Screws GN 801
Clamping Arm Extenders GN 801.1
Clamping Arm Extenders GN 801.2
Clamping Arm Extenders GN 809.1
