AN | On the chamfer, above |
AR | On the chamfer, below |
FN | In the front, above |
FR | In the front, below |
R | Digits ascending clockwise |
L | Digits ascending anti-clockwise |
Counter Indication after one spindle revolution | Indication after one spindle revolution | Indication after one spindle revolution | Indication after one spindle revolution | corresponds to thread pitch | max. revolutions per minute |
---|---|---|---|---|---|
00005 | 0000.5 | 000.05 | 00.005 | 0,5 | 1500 |
00010 | 0001.0 | 000.10 | 00.010 | 1 | 1500 |
00015 | 0001.5 | 000.15 | 00.015 | 1 | 1500 |
00020 | 0002.0 | 000.20 | 00.020 | 2 | 1250 |
00025 | 0002.5 | 000.25 | 00.025 | 2,5 | 1000 |
00030 | 0003.0 | 000.30 | 00.030 | 3 | 830 |
00040* | 0004.0* | 000.40* | 00.040* | 4 | 625 |
00050 | 0005.0 | 000.50 | 00.050 | 5 | 500 |
00060 | 0006.0 | 000.60 | 00.060 | 6 | 415 |
00080 | 0008.0 | 000.80 | 00.080 | 8 | 315 |
00100 | 0010.0 | 001.00 | 00.100 | 10 | 250 |
When mounting the position indicator, an appropriately situated mounting hole is required for the torque support. |
If the position indicator is used with smaller shaft diameters, the hollow shaft diameter Ø 20 H7 can be reduced with adapter bushings GN 952.1. |
||||||||||
Clamping Plates GN 953.7 can be used to clamp spindles after adjustment to secure them against independent or accidental turning. |
If reduction is desired in addition to installation of a control knob, control knobs GN 957 are available, which combine both functions in a single element. |
||||||||||
The position indicator is equipped with a hollow shaft that is slid directly onto the spindle and is connected to the spindle by a grub screw. The spindle rotations are transmitted to a counter directly by a gearbox. For torque support, a pin of the housing projects into a hole made on the machine side, establishing the position relative to the mounting site. |
|||||||||||
The transmission ratio and counting direction of the counter are determined by the pitch of the adjusting spindle. The indicated value after one turn starting from the 0 position serves as a characteristic value. Decimal places are indicated in red. |
Our service team is available from Monday to Friday between 7:00 AM and 5:30 PM: +49 7723 6507 - 0