GN 282.10 Swivel Clamp Connector Joints Plastic

In the initial position, the clamping bore axis of the swivel clamp connector joints GN 282.10 is parallel to the flange surface and can be swiveled by ±90°. It holds typical construction tubes with full surface contact over the entire cross-section of the bore.

At the screw location z₁, the socket cap screw reduces the bore cross-section for clamping. Adapter bushings GN 290 can be used to reduce the bore cross-sections to smaller diameters.

The screw location z₂ serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.

For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN 911.9 listed in the table as accessories.

Specification

Connector clamp
Plastic, Polyamide (PA)

• Glass fiber reinforced
• Operating temperature -20 °C to +100 °C
• Black, RAL 9005, matte finishSW
• Gray, RAL 7040, matt finishGR

Socket cap screws ISO 4762
Stainless steel AISI 304

Hex nuts DIN 985
Stainless steel AISI 304
Self-locking with polyamide ring

RoHS

Accessory

Construction Tubes GN 990 (Aluminum)
Construction Tubes GN 990 (Stainless Steel )
Adapter Bushings GN 290
Adjustable Hand Levers GN 911.9