GN 282.9 Swivel Clamp Connector Joints Plastic

Information

In the initial position, the clamping bore axis of the swivel clamp connector joints GN 282.9 is perpendicular to the flange surface and can be swiveled by ±90°. It holds typical construction tubes with full surface contact over the entire cross-section of the bore.

At the screw location z₁, the socket cap screw reduces the bore cross-section for clamping. Adapter bushings GN 290 can be used to reduce the bore cross-sections to smaller diameters.

The screw location z₂ serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.

For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN 911.9 listed in the table as accessories.

Specification

Plastic
Technopolymer (Polyamide PA)

• Glass fiber reinforced
• Temperature resistant up to 100 °C
• Black, RAL 9005, matte finishSW
• Gray, RAL 7040, matt finishGR

Socket cap screws DIN 912
Stainless steel AISI 304

Hex nuts DIN 985

• Stainless steel AISI 304
• Self-locking with polyamide ring

RoHS